Mounting a Power-Pole Micro on the Jackson Cuda 14

Some of you may remember I got a new toy for the Cuda awhile back, the Power-Pole Micro anchoring system:

IMG_2565

I’d love to give a review on it, but unfortunately it has been sitting in that box in my garage, unused, for several months.  I haven’t gotten a chance to use it because there wasn’t an easy way for me to mount it on the Cuda.  The Power-pole Micro comes with it’s own adjustable bracket mount, but another bracket is still needed to get it to fit right/anchor properly on the back of the Cuda.  My options were to fab something up of my own or wait patiently until a commercial mounting bracket was available.  I chose to wait because I trust the folks at YakAttack a heck of a lot more than I trust myself when it comes to kayak rigging.  I also didn’t mind waiting because I really didn’t want to have to run power to the unit and I knew a battery pack for the Power-Pole would be available in October.  So with the bracket for the Cuda now offered by YakAttack online, it will be sooner than later that I will get a chance to use it!

The installation of the bracket is actually really easy, the hardest part is getting over the fear of drilling holes in a kayak.  It doesn’t matter what I’m installing on a kayak there is a lump in my throat every time I put that drill bit(or rivet gun) to the plastic – you’d think by now this would be no big deal for me, but that’s not the case.  So I always measure and line everything up a trillion times before I do anything. Here is what is included from YakAttack:

IMG_3402

No instructions came with the mounting bracket.  I’m not sure if that was an oversight or the product is so new that none have been typed up, but you’re in luck because Damon Bungard of Jackson Kayak has already posted an instructional video going through the process with a prototype mount.:

Tools you’ll need:

– Drill

– Phillips head screwdriver

– 15/64 drill bit

– 7/16 socket or open ended wrench

As you can see in the video it is pretty simple, so simple you probably don’t even need instructions.  The main thing is to just line the bracket up parallel with the handle on the left.  The bigger holes that mount the YakAttack bracket go over the kayak, while the smaller holes, which are for the Micro anchor, sit with two of the holes over the water.  The bigger holes on the right follow the contour of the boat:

IMG_3403

IMG_3405

Then drill your first hole:

IMG_3406

After the first hole is drilled you can mount the first screw to make sure the rest of your holes line up. Remember you’re drilling into the bigger holes, not the smaller ones:

IMG_3407

IMG_3408

When you have all four holes drilled and and your screws in place, you can open the rear hatch of the Cuda and tighten down the locking nuts:

IMG_3414

IMG_3411

IMG_3415

IMG_3413

With the YakAttack bracket mounted and tightened you can now install the Power-pole mount, with screws that come in the YakAttack mounting kit:

IMG_3417

IMG_3418

IMG_3419

IMG_3420

As you can see the YakAttack mounting bracket is designed to work with or without a rudder, as the Power-Pole will anchor off to the right side of the boat.  Installation was super easy and with the YakAttack bracket it was super clean as well. I look forward to getting that battery pack in so I can finally put this anchor to use and see what the fuss is all about.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: